Spider Racing Clip-On Handlebar Kit - HSBK-50.25.239.51

Previous productWoodcraft Billet Top Clamp ...

Next productK-Tech DDS Pro Rear Shock -...

Spider Racing Clip-On Handlebar Kit For RS660 *See detailed fitment list*

Availability: 2 In stock -- Ready to Ship Now!

SKU: HSBK-50.25.239.51

$236.81 (USD)

Qty:

Spider Racing Clip-On Handlebar Kit

These clip-ons are required if you're planning on running the Spider Racing Top Clamp

CNC machined from 7075 Billet Aluminum

Spider describes these clip-ons as 25mm offset (see attached image), but that 25mm offset (viewed from above) is pretty typical and about the same dimension as the stock RS660 bars. Of perhaps greater importance is that the bars sit some 40mm (1.5 inches) lower than the stock bars. This will result in significant interference with the stock bodywork. Especially regarding the front brake lever contacting the fairing and the front brake master cylinder and reservoir contacting the dashboard, and front fairing.

Also note, these clip-ons are not pre-drilled for the locator pins found on the RH and LH switch groups. You will need to drill at least 2 4mm holes in these clip-ons when you install them.