Evotech License Plate Bracket
Complete fitment list at bottom of this page.
This is, by far, the best selling license plate bracket set up offered by AF1 Racing.
CNC machined from lightweight Aluminium; this cleverly designed one piece unit uses an included smaller license plate light. A subtle provision for mounting the original turn signals is also built into the bracket.
Attaches to all existing mountings.
Supplied with easy to follow .pdf instructions and all fittings, including a separate reflector mounting bracket.
*Please note: While Evotech did a fantastic job of seamlessly integrating the stock turn signals into the design of this bracket, bolting on aftermarket turnsignals will be significantly more challenging due to the bracket's ultra slim housing. If bolting on Rizoma or other aftermarket brand turn signals with an M8 diameter thread (stock Aprilia is M6, or 6mm), the Rizoma turn signal extender stalks are STRONGLY recommended. If you do not use the Rizoma extender stalks AND your license plate is set in the highest (most tucked) position, most aftermarket signals will be at least partially, if not entirely, covered by the license plate when viewed from the rear as this photo attempts to illustrate.
Rear view with stock turn signals and the license plate set in the hightest position
Rear view with Rizoma turn signals and the extender bracket linked above
May not be street-legal in all states. Check your state laws before ordering.